BED SHEETS. BLANKETS and PILLOW

What is described here is for twin beds so you should keep that in mind.

MATTRESS COVER

Both Comco and Fetware sell fitted matress protectors that can be used as bottom sheets. The Comco one is translucent and can be put over a matress cover with a color or design that will show through and add a very special touch. If you use a heating item and you want Baby to have only rubber where she can feel her bedclothes, put it under the matress cover or get one that is designed specially for that purpose. You can use it to pre-warm Baby's bed as rubber bedlothes tend to get cold in the winter. You will want to put powder on the sheets whtn you put Baby to bed.

For a "comforter" you can use a shower curtain made of thick material with a pretty design on it.

SHEETs and BLANKET

We recommend the comco-style material, characterized by being thick and smooth, or something like it. If you wish, you may dye the blanket or color it in some other way. the blanket is made the same way as the top sheet.

TO MAKE

1. Cut 2 pieces of the material so that it is the full width; 51 inches and 90 inches long.
2. For the bottom sheet, lay the material with the glossier side up. At each end attach tuck flaps at the left and right that go under the mattress.
3. the "draw sheet" is just a 1 x 2 yard of rubber that goes where Baby's chastity area is. It is just another layer of rubber. This is used for babies over the cloth bottom crib sheet which is over the rubber sheet that protects the mattress.
4. Using the glossier side as the bottom, attach along the side a full-length or 3 shorter "tuck flapes" these can be made of any material. We recommend the flannel backed tablecloth material with the flannel on the bottm so that it does not slide under the matress when it is tucked in. These flaps should be about 20 inches wide to fit well under the matress and stay in place.

TO USE

Bottom and top sheets:Simply tuck the added materil fully under the matress as though it ware an ordianry sheet or blanket and tuck the end in at the foot of the bed. The draw sheet is laid lengthwise across the bottm sheet where Baby's chastity area will be and both ends are tucked in

COVERING THE PILLOW
Get a King size pillow, this will have room for both Little Girl and Dolly and coverit with rubber completely
After that you will want to get some other meterial to make pillow covers that will be changed with the bedlinens. This is becuase the material deteriorates over time being close to the body so if you have several and change them, they will last longer.

This is what the bottom of the pillow will look like when you are finished

TO MAKE:
  1. Get some material that when folded around the pillow, looks like the picutre,note the wihte lines marking the edges.
  2. fold and attach the edges around the pillow as shown
  3. Cut a long narrow stirp of material to act as a "strap' to hold things in place. Notice that there is a good deal of overhang.
  4. Cut a smaller piece to act as a loop to put the strap in
  5. Attach the strpa securly at the top and attach the two ends of the loop so that the strap will go through the loop and have some excess.
  6. OPTION: Cut a pice of each kind o velcro and put the furry pice on the end of the strap and the scratchy piece where the end of the strap will be to hold it in place
Put the pillow inside the case and thread the strap through the loop and, if you are using velcro, fasten them. Turn the pillow over so that this will be the bottom and place the pillow on the bed